28 Jul 2026 • 9 mins read
Fixing a clogged nozzle for good: the cold pull method
Poking the nozzle with a needle only delays the problem. A cold pull at the right temperature lifts the carbonised residue out in one piece.
Enes Aydın
Blog
Print settings, maintenance and material notes. Everything here was tried on my own machine and measured.
21 Jul 2026 • 12 mins read
PLA, PETG and ASA: which filament for which part?
Printing a part that lives in a car in PLA is wasted time. Heat resistance, brittleness and print difficulty compared side by side.
Deniz Korkmaz
14 Jul 2026 • 7 mins read
First layer will not stick: a 7-step diagnosis list
What to check, in order, before reaching for glue. Most of the time the culprit is not z-offset but a film of oil on the bed.
Enes Aydın
6 Jul 2026 • 8 mins read
Retraction settings and how to read a stringing test
Starting values differ for Bowden and direct drive. Print the tower and measure the layer where stringing stops.
Selin Arda
29 Jun 2026 • 10 mins read
Bed levelling: manual mesh or automatic probe?
A probe does not fix a warped bed, it only compensates. When mechanical adjustment is mandatory and when software is enough.
Enes Aydın
22 Jun 2026 • 6 mins read
Drying filament: how moisture actually ruins a print
The crackling sound while printing wet PETG is water flashing to steam inside the nozzle. What six hours at 50°C does to surface quality.
Deniz Korkmaz
Posts published
9
Models released
6