28 Jul 2026 • 9 mins read
Fixing a clogged nozzle for good: the cold pull method
Poking the nozzle with a needle only delays the problem. A cold pull at the right temperature lifts the carbonised residue out in one piece.
Enes Aydın
Latest posts
The newest of my print settings, maintenance and material notes.
21 Jul 2026 • 12 mins read
PLA, PETG and ASA: which filament for which part?
Printing a part that lives in a car in PLA is wasted time. Heat resistance, brittleness and print difficulty compared side by side.
Deniz Korkmaz
14 Jul 2026 • 7 mins read
First layer will not stick: a 7-step diagnosis list
What to check, in order, before reaching for glue. Most of the time the culprit is not z-offset but a film of oil on the bed.
Enes Aydın
Featured projects
Parts whose drawings I share, and how they were made.
25 Jul 2026 • 6 mins read
Modular filament spool holder
A bearing-mounted holder that clips together side by side. Prints in one piece with no supports; dimensioned drawing and assembly order inside.
Enes Aydın
11 Jul 2026 • 8 mins read
Cable management channel for the printer
A channel that gathers the harness swinging behind the gantry. Print orientation and wall count chosen to stop it flexing.
Selin Arda
27 Jun 2026 • 14 mins read
Parametric screw box: step by step in Fusion 360
One parameter table drives compartment count and depth. Every sketch constraint is walked through screen by screen.
Enes Aydın
Posts published
9
Models released
6