What to check, in order, before reaching for glue. Most of the time the culprit is not z-offset but a film of oil on the bed.
Technical
First layer will not stick: a 7-step diagnosis list
Enes Aydın14 Jul 2026 • 7 mins read
Latest posts
29 Jun 2026 • 10 mins read
Bed levelling: manual mesh or automatic probe?
A probe does not fix a warped bed, it only compensates. When mechanical adjustment is mandatory and when software is enough.
Enes Aydın
6 Jul 2026 • 8 mins read
Retraction settings and how to read a stringing test
Starting values differ for Bowden and direct drive. Print the tower and measure the layer where stringing stops.
Selin Arda
8 Jun 2026 • 11 mins read
Print a flow rate test, not another calibration cube
A cube measuring 20 mm does not mean your printer is calibrated. A practical way to find the extrusion multiplier with a single-wall test.
Enes Aydın